silent_killer
Member
If I am understanding 922r correctly, I would have to replace 4 parts with US made parts in order to install the Imported collapsing stock. The current import count on a Benelli M4 is 13 parts (since the stock setup is legal for import, the 13 is ok, but in order to change parts, I have to abide by the 10 count), you need no more than 10 to be 922r compliant, so since the collapsing stock is 2 parts (PG and Stock), I would need to replace 4 parts to install that stock and be compliant correct?
So I am going to change the following:
U.S. Made Mag Tube
U.S. Made Follower
U.S. Made Hammer
U.S. Made Forearm
So if I change these 4 parts, I should be OK for 922r Compliance correct?
Thanks for any input!
One last question, if I were to replace the Mag Tube with a 7 round extended tube (full tube, not an extension), I need to find another U.S. built part to replace even if the mag tube is US built correct? (because its deemed an "evil" part)
So I am going to change the following:
U.S. Made Mag Tube
U.S. Made Follower
U.S. Made Hammer
U.S. Made Forearm
So if I change these 4 parts, I should be OK for 922r Compliance correct?
Thanks for any input!
One last question, if I were to replace the Mag Tube with a 7 round extended tube (full tube, not an extension), I need to find another U.S. built part to replace even if the mag tube is US built correct? (because its deemed an "evil" part)
Last edited: