Inebriated
Member
I'm ready to throw this gun through the window. Bought it four hours ago... no rounds through it, no disassembly, nothing.
Now... Here is what's happening.
-magazine goes in fine until it get's to magazine release, then it meets a lot of resistance, and has to be tapped in. Removal requires a thin screwdriver to pull it down.
-no matter if there is a mag or not, the bolt comes back 3/4 way, there's resistance, and then with a hard pull, it goes back all the way.
-bolt gets stuck in rearward position, and can be pushed forward, as long as mag is out/bolt release is down.
-mainspring housing will move out about a quarter of an inch, then won't move at all.
I think that's all of it. I have no idea what's up. I'd like to be able to fix this without having to contact Ruger after only having it for a few hours. Any ideas?
Now... Here is what's happening.
-magazine goes in fine until it get's to magazine release, then it meets a lot of resistance, and has to be tapped in. Removal requires a thin screwdriver to pull it down.
-no matter if there is a mag or not, the bolt comes back 3/4 way, there's resistance, and then with a hard pull, it goes back all the way.
-bolt gets stuck in rearward position, and can be pushed forward, as long as mag is out/bolt release is down.
-mainspring housing will move out about a quarter of an inch, then won't move at all.
I think that's all of it. I have no idea what's up. I'd like to be able to fix this without having to contact Ruger after only having it for a few hours. Any ideas?