M2HMGHB
Member
How much of a difficulty is it to have a 6 inch barrel replaced with a 2.5 inch? The gun in question is a model 19-5. Any ideas where to find a good barrel too?
Model 19 questions
- Thread starter M2HMGHB
- Start date
- Status
dfariswheel
Member
- Joined
- Dec 26, 2002
- Messages
- 6,662
Doing a barrel change is easily do-able.....for pistolsmiths with the correct tooling and knowledge to do it RIGHT.
You will have to be sure to get a barrel of the same vintage, since S&W has made some changes to the barrels over the years.
One way to get the right barrel, and get it installed PROPERLY, would be to send your gun in to S&W and let the experts do the job.
In the long run, this will usually cost less, and will have less aggravation with getting the wrong barrel, or a defective barrel, Etc.
You will have to be sure to get a barrel of the same vintage, since S&W has made some changes to the barrels over the years.
One way to get the right barrel, and get it installed PROPERLY, would be to send your gun in to S&W and let the experts do the job.
In the long run, this will usually cost less, and will have less aggravation with getting the wrong barrel, or a defective barrel, Etc.
Standing Wolf
Member in memoriam
The good folks at http://cylinder-slide.com have swapped barrels for me a time or two. They did good work. I didn't say they did cheap or fast work. I said they did good work.
Pa. Patriot
Member
Definately send it to S&W or a properly equiped smith.
As mentioned above barrel changes are simple task for those so equipped.
As mentioned above barrel changes are simple task for those so equipped.
LeonCarr
Member
IME for what you pay for a barrel and a quality installation you can probably buy another model 19 with a 2.5 inch barrel.
Just my .02,
LeonCarr
Just my .02,
LeonCarr
Pa. Patriot
Member
You must not have priced mod19's lately 
Expect to pay half as much for the bbl + swap.
Expect to pay half as much for the bbl + swap.
- Status
