jeeptim
Member
Hey Guys
Went to the range on Fri and shot my mosin 91/30 it has been upgraded a bit.
Bedded in an ATI stock with a timney trigger set to 2lb an rock solid scope mount with a simmons mil dot white tail scope and a bi-pod shooting factory PPU 150gr. at 100yds.
Took about 15 rds to get it dialed in 5 rds dead center other 4 3/4 inch or less out then I started shooting at a clean target that was posted below and bupkis all over the place no grouping all about 10 inches apart burned up that 20 rnds and had nothing to work with to adjust.
I checked every locktighted screw mount all seemed good with the rifle.
Ol'most seemed that once it warmed up all went bad. The ammo was of the same lot I am just at a loss.
Went to the range on Fri and shot my mosin 91/30 it has been upgraded a bit.
Bedded in an ATI stock with a timney trigger set to 2lb an rock solid scope mount with a simmons mil dot white tail scope and a bi-pod shooting factory PPU 150gr. at 100yds.
Took about 15 rds to get it dialed in 5 rds dead center other 4 3/4 inch or less out then I started shooting at a clean target that was posted below and bupkis all over the place no grouping all about 10 inches apart burned up that 20 rnds and had nothing to work with to adjust.
I checked every locktighted screw mount all seemed good with the rifle.
Ol'most seemed that once it warmed up all went bad. The ammo was of the same lot I am just at a loss.