mahansm
Member
I'm setting up a new bench and plan on it being multipurpose. I've just received strong mounts for my RL 550B and Square Deal B. I'm wondering if anyone knows what the side to side mounting hole spacings for the workbench are for the two presses. The front/back spacing is the same for both.
I'd like, if possible, to use the same footprint for both presses, putting studs into the bench (well, captive through bolts) so that I can place the press I'm planning to use on the bench, use four nuts, and proceed. Both presses will normally live in a cabinet near the bench.
If the lateral space is large enough, 6 studs will allow me to mount either press, leaving a pair of studs beside one of the strong mounts.
I'd like, if possible, to use the same footprint for both presses, putting studs into the bench (well, captive through bolts) so that I can place the press I'm planning to use on the bench, use four nuts, and proceed. Both presses will normally live in a cabinet near the bench.
If the lateral space is large enough, 6 studs will allow me to mount either press, leaving a pair of studs beside one of the strong mounts.