[email protected]
Member
- Joined
- Aug 21, 2008
- Messages
- 2,153
With the shortage of caps, and 2014 not looking good, I wish I was younger
and still working in the tool & die shop I would make these again. I could even
make them to fit revolvers. All you do is put a small pistol primer in, and screw
on the firing pin and shoot. I made this 50 years ago. I made up about 50 of
them and sold them for 5.00 The last ones were all stainless. If we only knew.
When I was into heavy bench shooting I thought at one time modern primers might be better for
accuracy. So I changed my nipples to use small pistol primers. I was wrong. Primers were no better
than caps. To use this nipple, just flick out the anvil on the small primer and put the primer right on
the nipple and shoot. Worked fine.
and still working in the tool & die shop I would make these again. I could even
make them to fit revolvers. All you do is put a small pistol primer in, and screw
on the firing pin and shoot. I made this 50 years ago. I made up about 50 of
them and sold them for 5.00 The last ones were all stainless. If we only knew.
When I was into heavy bench shooting I thought at one time modern primers might be better for
accuracy. So I changed my nipples to use small pistol primers. I was wrong. Primers were no better
than caps. To use this nipple, just flick out the anvil on the small primer and put the primer right on
the nipple and shoot. Worked fine.
Last edited: