mgmorden
Member
I just found this kinda neat and figured I'd share. I recently got an RCBS RC Supreme and its pretty nice, but I have to admit that I am a tad jealous of the "tube" primer disposal on the Lee Classic Cast.
While I was browsing around though I found the files for a 3d-printed catcher for it on Thingiverse (a website that lets people post 3D printable models of stuff they have made). It still sits behind the ram like the standard one but rather than the little cups you can add a flexible tube to divert the primers to a can or wherever you want. I downloaded the files and had a local guy print it out for me (cost me ~$20). Haven't connected the tube yet (don't have the right size and haven't made it to the store), but I've checked it for functionality and the primers seem to pop through just fine.
I may drill a small hole on the left hand side though and install a set-screw to hold it a little better. as it is it seems to work fine but the hold to the press isnt very tight.
Files are at:
www.thingiverse.com/thing:148190
While I was browsing around though I found the files for a 3d-printed catcher for it on Thingiverse (a website that lets people post 3D printable models of stuff they have made). It still sits behind the ram like the standard one but rather than the little cups you can add a flexible tube to divert the primers to a can or wherever you want. I downloaded the files and had a local guy print it out for me (cost me ~$20). Haven't connected the tube yet (don't have the right size and haven't made it to the store), but I've checked it for functionality and the primers seem to pop through just fine.
I may drill a small hole on the left hand side though and install a set-screw to hold it a little better. as it is it seems to work fine but the hold to the press isnt very tight.
Files are at:
www.thingiverse.com/thing:148190