Hello all,
Been lurking for a while now. Reading and learning a lot. I really enjoy this site. I want to say hello and also dive into the water here!
I have a question for all you guru's out there. I have cast some 9mm Luger bullets from a Lee 90402 mold. I have to seat the bullet to an over all length of 1.09" to get them to feed into my EAA Witness match. I am very cautious with this because the OAL seems to be very short. I have HS-6, Unique, Bullseye,hp-38 & 231 powders. My question is does anyone have a load for this bullet or a starting place to begin my endeavor? I would like to use the HS-6 as I have an 8lb jug of it. Thanks in advance for yall's help.
Here is a link to Lee's site showing the bullet if that helps.
http://www.leeprecision.com/cgi/cata.../bullmol2.html
George
Been lurking for a while now. Reading and learning a lot. I really enjoy this site. I want to say hello and also dive into the water here!
I have a question for all you guru's out there. I have cast some 9mm Luger bullets from a Lee 90402 mold. I have to seat the bullet to an over all length of 1.09" to get them to feed into my EAA Witness match. I am very cautious with this because the OAL seems to be very short. I have HS-6, Unique, Bullseye,hp-38 & 231 powders. My question is does anyone have a load for this bullet or a starting place to begin my endeavor? I would like to use the HS-6 as I have an 8lb jug of it. Thanks in advance for yall's help.
Here is a link to Lee's site showing the bullet if that helps.
http://www.leeprecision.com/cgi/cata.../bullmol2.html
George