WestKentucky
Member
I broke my kinetic bullet puller today trying to break down a heavily crimped 357 round just to ease my mind after second guessing myself after a few test loads got built.
Whats the best way to go for a bullet puller? I dont plan to use it a whole lot, and since i do put a heavy crimp on 357 and 38 im not too sure that i need to buy another kinetic puller just to beat it up and break another one trying to get the bullet to move. Suggestions would be appreciated. Until then, my old kinetic puller (sans-handle) is duct taped to a broom handle and it still ont budge the bullet and its rather awkward to swing now. I may try a golf club handle tomorrow as i just need to pull 1 to weigh.
Whats the best way to go for a bullet puller? I dont plan to use it a whole lot, and since i do put a heavy crimp on 357 and 38 im not too sure that i need to buy another kinetic puller just to beat it up and break another one trying to get the bullet to move. Suggestions would be appreciated. Until then, my old kinetic puller (sans-handle) is duct taped to a broom handle and it still ont budge the bullet and its rather awkward to swing now. I may try a golf club handle tomorrow as i just need to pull 1 to weigh.