Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

new mark II owner

Discussion in 'Handguns: Autoloaders' started by spacemanspiff, Dec 29, 2003.

Thread Status:
Not open for further replies.
  1. spacemanspiff

    spacemanspiff Senior Member

    Joined:
    Dec 24, 2002
    Messages:
    4,067
    Location:
    alaska
    well i traded off a couple pistols for a used Mark II plus cash. wasnt shooting my 9mm's much, so i took them and my m40 to a mom-n-pop store, was close to just letting them give me all cash but that mark II stainless with bull barrel was just too tempting to pass up.

    felt pretty good unloading four guns, taking one new one home, half a case of .45acp ammo plus a couple hundred bucks. forget the walther p22, this ruger is more to my liking.

    anyone have any suggestions if the sights should be replaced with something better?
     
  2. 45R

    45R Member

    Joined:
    Dec 25, 2002
    Messages:
    3,692
    Location:
    No Place Like Home
  3. Jim K

    Jim K Member

    Joined:
    Dec 31, 2002
    Messages:
    17,566
    Unless there has been a change, the bull barrel come with a darned good set of adjustable sights. Just from curiosity, what do you want to change to?

    Jim
     
  4. XavierBreath

    XavierBreath Member

    Joined:
    Jan 6, 2003
    Messages:
    5,054
    Location:
    Louisiana
  5. spacemanspiff

    spacemanspiff Senior Member

    Joined:
    Dec 24, 2002
    Messages:
    4,067
    Location:
    alaska
    not sure what i want to change to. i'll wait until i take her to the range before deciding. my first impression is that the front sight post is rather high. i did find a site that has replacement posts that provide a better sight picture.
     
  6. Ron L

    Ron L Member

    Joined:
    Dec 24, 2002
    Messages:
    173
    Location:
    Livonia, MI
    You'll love that gun, it's a sweetheart to shoot.

    The only mod I made to the sights was to file the back-cut part of the ramp off, touch up the sight with some orange paint, change the elevation of the rear sight slightly and it was good to go.
     
Thread Status:
Not open for further replies.

Share This Page