Howdy, just picked up an SP101 (357) new.
It's DAO (bobbed hammer)
Question
I noticed that when I pull the trigger, and then slowly release to allow it to reset, there is no "lock-up" point. In other words, while releasing the pulled trigger, there is no spot where the trigger locks if you try to pull it again before allowing it to fully reset to normal position. It just does a trigger pull with no result.
When doing this with my GP100, there is a phase in the trigger cycle where the trigger locks still if you try and pull it back before resetting.
Problem or good to go?
It's DAO (bobbed hammer)
Question
I noticed that when I pull the trigger, and then slowly release to allow it to reset, there is no "lock-up" point. In other words, while releasing the pulled trigger, there is no spot where the trigger locks if you try to pull it again before allowing it to fully reset to normal position. It just does a trigger pull with no result.
When doing this with my GP100, there is a phase in the trigger cycle where the trigger locks still if you try and pull it back before resetting.
Problem or good to go?