Newbie Revolver Question - Ruger Security Six

[brufener]

I bought a Ruger Security Six .357 for my first gun not too long ago (I also shoot a Mark II that belongs to the club I shoot with). I was putting some ammo in it and I noticed that when I tip the gun up (i.e. point it at the sky), the .38 special cartridges in the lower chambers (i.e. the 3 chambers furthest away from the barrel) slide backwards (i.e. towards the grip) about 3mm. My question is, if I were to fire the gun would the 3 bullets which slide backwards prevent the cylinder from turning?

I would try it myself, but I don't have anywhere where I can safely shoot at that angle. I suppose it isn't a big deal - I guess it would only come into play if I was shooting at someone on a rooftop (not likely), but I'm still curious.

Bryce

 

[Troy 66]

I just loaded my Security Six and it does about the same thing and have shot hundreds of rounds. So I would say nothing to worry about, think you will find is one fine shooting revolver.Had mine about 6 month and has the 6 inch barrel like it so much looking for a 4 inch

 

[Starter52]

Don't worry about it. I've had my Security Six for 19 years and never had a problem with it.

 

[JamisJockey]

I just loaded my Security Six and it does about the same thing and have shot hundreds of rounds. So I would say nothing to worry about, think you will find is one fine shooting revolver.Had mine about 6 month and has the 6 inch barrel like it so much looking for a 4 inch

+1 mine does the same thing. Never had a single problem and about 1000 rounds of .38 through it

 

[slopemeno]

The Security Six is about the toughest medium frame revolver ever built. Mine has been super reliable since 1980. Dont worry about it. Shoot it.

 

[Dienekes]

No. Examine the standing breech (the frame behind the cylinder when closed) and you will see where the surfaces allow this movement while bevelling the uppermost round forward slightly when it rises into battery. Trust me on this.

BTW the only two things that you do have to look out for on this (or any other revolver) are crud under the extractor star or the ejector rod loosening over time. Keep the first immaculate and dry, and monitor the second. If necessary use a drop of medium strength loc-tite to keep it tight.

Sixs are probably the most durable and reliable revolver ever made. I have been carrying one since 1980. When I find a better one I will buy it on the spot.