No more oversize .454" balls for me!
I shot some through my full sized '58 Remmie and just slightlly bent the loading lever cramming them in the cylinder.
Now I can't get the lever to stay up!!!
I am afraid that the lever or the base pin took some damage while trying to repair the impercieveablly bent laver. You can't even see a warp but one must be there!
Any ideas on how to fix this lever?
I have considered trying to lengthen the slot in the plunger pin to allwo greater purchase for the little plunger end on the stud. Ideas on that?
I tried the oversized balls in an atttempt to obtain a better gas seal in the cylinder to get better consistancy between shots. Guess I really blew it!
ZVP
I shot some through my full sized '58 Remmie and just slightlly bent the loading lever cramming them in the cylinder.
Now I can't get the lever to stay up!!!
I am afraid that the lever or the base pin took some damage while trying to repair the impercieveablly bent laver. You can't even see a warp but one must be there!
Any ideas on how to fix this lever?
I have considered trying to lengthen the slot in the plunger pin to allwo greater purchase for the little plunger end on the stud. Ideas on that?
I tried the oversized balls in an atttempt to obtain a better gas seal in the cylinder to get better consistancy between shots. Guess I really blew it!
ZVP
Last edited: