ManOfTheWest
Member
- Joined
- Feb 26, 2009
- Messages
- 13
I know there are a few folks on here who have the NEF Pardner Protector (tactical shotty). I find the recoil unbearable so, as a solution, I bought the Knoxx Spec Ops Stock from Blackhawk. Installation was a cinch, except for one thing: there's almost an INCH gap between the receiver and stock. In fact the stock is sliding back and forth that one inch.
Those of you who use the Knoxx, tell me: is the pre-installed HEX HEAD BOLT in the stock supposed to move back and forth so loosely? This seems to be the problem, but I could be wrong. Note that I removed the spacer as per instructions. I tightend the hex bolt with the extended rounded allen wrench as far as it will go. Still lots of gap. Obviously something is wrong.
Opinions?
Those of you who use the Knoxx, tell me: is the pre-installed HEX HEAD BOLT in the stock supposed to move back and forth so loosely? This seems to be the problem, but I could be wrong. Note that I removed the spacer as per instructions. I tightend the hex bolt with the extended rounded allen wrench as far as it will go. Still lots of gap. Obviously something is wrong.
Opinions?