Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Pillar Bedding a Tikka

Discussion in 'Gunsmithing and Repairs' started by Bernie B, Jun 7, 2004.

Thread Status:
Not open for further replies.
  1. Bernie B

    Bernie B Member

    Joined:
    May 10, 2004
    Messages:
    13
    Location:
    Lakeland, Fl
    I have a Tikka T3 Lite (synthetic stock) that I was thinking of pillar bedding. This would be the first time that I have bedded an action. After taking the action apart and looking at it I am now wondering if it will be practical to attempt. Two things concern me. The action mates to the stock in two relatively small flat areas. The alluminum pillars that I have are not a snug fit ( diameter wise) for the stock screws. These are your basic adjustable pillars distributed by Brownell's. Has anyone bedded a Tikka action, and or does anyone have suggestions?:confused:

    Thanks,

    Bernie
     
Thread Status:
Not open for further replies.

Share This Page