The split tubular pin that holds the front of the Taurus' adjustable rear sight on the slide shook to bits several times. It was replaced the last time with a fitting piece of a drill bit and lok-tited in place.
The hard bit ate thru the top of the hole so that now there's a visible crack on the left side hole towards the top of the slide (in the, say, .7mm of metal there is...).
Anyone think there's a way to repair this? Or should I just go to the importer's for a new slide (this time a mod. 92 slide to avoid the whole rear sight fiasco :banghead: )?
The hard bit ate thru the top of the hole so that now there's a visible crack on the left side hole towards the top of the slide (in the, say, .7mm of metal there is...).
Anyone think there's a way to repair this? Or should I just go to the importer's for a new slide (this time a mod. 92 slide to avoid the whole rear sight fiasco :banghead: )?