Monster Zero
Member
- Joined
- Mar 4, 2008
- Messages
- 595
Doing a second action/trigger job on an SP101 according to the MCARBO video that's available. The first SP101 went well, considering it was one's first try at it. Had to buy a new pawl spring but hey, no big deal.
This time, when finishing up the reassembly and installing the new mainspring assembly, the action will work in single action just fine. However, trying to get it to cycle in double action, the trigger doesn't reset with whatever it's supposed to inside there and it just moves back and forth but doesn't do anything.
I suppose one could just tear the whole thing down and start over... not really looking forward to messing with that pawl spring again though. Anyone have any suggestions about what might be the problem that one could check for an easy fix? So far I've taken the whole thing apart, refitting the hammer shims and then put it back together a couple dozen times or so.
Help!
TIA
This time, when finishing up the reassembly and installing the new mainspring assembly, the action will work in single action just fine. However, trying to get it to cycle in double action, the trigger doesn't reset with whatever it's supposed to inside there and it just moves back and forth but doesn't do anything.
I suppose one could just tear the whole thing down and start over... not really looking forward to messing with that pawl spring again though. Anyone have any suggestions about what might be the problem that one could check for an easy fix? So far I've taken the whole thing apart, refitting the hammer shims and then put it back together a couple dozen times or so.
Help!
TIA