The wedge does not seat square in the barrel and is not flush on the frame locking pins.
When I check the depth of the base pin into the barrel it seems a couple thousands to long which would cause the wedge to not seat square
Question do I fine tune it or return to cabelas for an exchange, shoots great and the rest of the revolver seems good.
Just went out and fired a few so revolver is dirty in photo plus a little hard to see gap between barrel and frame
When I check the depth of the base pin into the barrel it seems a couple thousands to long which would cause the wedge to not seat square
Question do I fine tune it or return to cabelas for an exchange, shoots great and the rest of the revolver seems good.
Just went out and fired a few so revolver is dirty in photo plus a little hard to see gap between barrel and frame