PSA PA10 Problems

[PFCLEE11B]

I finally took my PA10 out to the range the other day and had several issues I am hoping were just break in issues but figured I would ask. I had 1 FTF there was a primer strike but no bang this was with brass cased ammo, there were also another 3 but did not appear to have any hammer strikes on the primer. I also had several failure to ejects all with brass cased ammo. My only problem with steel case was 1 FTE.

I did notice upon inspection of the brass that the brass appeared to be pretty beat up with a long metallic streak down the brass.

Just wondering if this is an issue I can fix or if it will work itself out over time as I only fired about 200 rds through the gun.

 

[C-grunt]

I remember reading a few weeks back that early PA10 rifles had something going on with the hammers not striking the firing pin correctly. I cant remember if it was a hammer problem or something to do with the lower. Ill see if I can find the thread.

 

[HankC]

Send it back to PSA.

 

[boricua9mm]

With these PSA .308s, there is an ongoing saga of people whose rifles will not go into battery. Sounds like you may be having this same problem.

 

[PFCLEE11B]

Had that originally but fixed with the right buffer spring but this is a new occurance