Range Report GP 100 10mm

[wankerjake]

My factory woods were so lose and had so much play, I **** canned them. I am pretty sure I got a defective pair.

That’s funny because mine are too. I had to shim them up. I called Ruger and they sent me another pair and those were loose too. Once shimmed I like them a lot. Interestingly I put the extra set on a 3” GP100 44Spl and they fit well, which leads me to believe they made the handle a little thin on the Lipseys model

 

[Pat Riot]

@jeff-10 Nice revolver. Thanks for the report.

Start with a cheap golf club from the thrift store or garage sale and about two minutes with a Dremel cut-off wheel and you have a very low cost de-mooner. It will also hold three to four moonclips worth of brass depending on original length and caliber you cut it off for.

View attachment 991954View attachment 991955

I look forward to hearing more about if and how you got it to run reliably with 40S&W.

Thank you for that. Great idea.

 

[sparkyv]

I took @mcb up on this golf club hack months ago. It works great!

Start with a cheap golf club from the thrift store or garage sale and about two minutes with a Dremel cut-off wheel and you have a very low cost de-mooner. It will also hold three to four moonclips worth of brass depending on original length and caliber you cut it off for.

View attachment 991954View attachment 991955

I look forward to hearing more about if and how you got it to run reliably with 40S&W.

@jeff-10 Nice revolver. Thanks for the report.




Thank you for that. Great idea.

 

[LeftyRed]

Love the 10mm in any revolver!