Hello. Like new 4" .44 mag ruger redhawk. When checking timing the gun is just fine. Pulling the hammer slow cylinder locks up before the hammer is all the way back as it should. When the hammer is lowered and the gun is in full lockup everytng is fine as well
However when the hammer is all the way back and you pull the trigger then release trigger to lower the hammer safely the cyclinder latch pops ever so slightly and unseats itself just a little bit. Only reason I would ever see doing this is go from sa fire to lower hammer on live round. Question I have is can someone with a redhawk try yhis to see if it is the trigger and spring setup on the redhawk, or if it is my gun? My gp100 does not do this, however the redhawk has the different spring setup fromm all the other ruger revo's.
Thanks
Jim
However when the hammer is all the way back and you pull the trigger then release trigger to lower the hammer safely the cyclinder latch pops ever so slightly and unseats itself just a little bit. Only reason I would ever see doing this is go from sa fire to lower hammer on live round. Question I have is can someone with a redhawk try yhis to see if it is the trigger and spring setup on the redhawk, or if it is my gun? My gp100 does not do this, however the redhawk has the different spring setup fromm all the other ruger revo's.
Thanks
Jim