Anyone have a picture that shows the correct orientation of the hammer reset spring on their P239? This is the small spring that sticks out on the left side of the hammer. I believe the other end is supposed to rest on the inside of the frame pocket the hammer sits in, but am not sure. A good photo of the fame with the slide off should show this clearly looking down on the left side of the hammer/frame area.
I would like to see if in fact the one I have is installed correctly on my P239. The other P series use a different hammer reset spring located behind the hammer, so this is unique to the P239.
Thanks,
I would like to see if in fact the one I have is installed correctly on my P239. The other P series use a different hammer reset spring located behind the hammer, so this is unique to the P239.
Thanks,