Hello.
Recently purchased a new GP100 3". Have not fired it yet but upon inspection i noticed this scratch, or uneven finish, not really sure which?? The revolver checks out fine, tiny bit of side to side play in cylinder, endshake and gap look fine, all other aspects of the revolver are ok.
Question is does this look like a scratch or just an uneven area that wasn't buffed out completely? Having not fired the revolver there is no way i could have caused this. Most importantly I just wanted to rule out that there might be something wrong with this revolver that I am missing? If it is just a spot that ruger missed when finishing it I am ok with this!...
If there is no reason for concern should i just leave it alone, or try and sand(buff) it out?
Thanks
Jim
Recently purchased a new GP100 3". Have not fired it yet but upon inspection i noticed this scratch, or uneven finish, not really sure which?? The revolver checks out fine, tiny bit of side to side play in cylinder, endshake and gap look fine, all other aspects of the revolver are ok.
Question is does this look like a scratch or just an uneven area that wasn't buffed out completely? Having not fired the revolver there is no way i could have caused this. Most importantly I just wanted to rule out that there might be something wrong with this revolver that I am missing? If it is just a spot that ruger missed when finishing it I am ok with this!...
If there is no reason for concern should i just leave it alone, or try and sand(buff) it out?
Thanks
Jim