Update on 3913 Trigger Job...
The springs came in, so I first replaced the Hammer(mainspring) with a 17 #. The factory was 20#. This noticebly reduced the pull, so at least I can set it off without shaking so badly. It dropped from the factory pull of 12 1/4# to 6 1/2 #'s..a nice differnece indeed. I will shoot it this way for awhile, as will others, and if not good enough I have also obtained two trigger return springs, a 2.5# and 3 # whereas the OEM is 4 #'s. These I'll try last, as I'm aware it takes keen knowdledge to reaseemble the pistol. I also found an aluminum trigger shoe, which I will try next to gain control over the extreme take up, and the fact my finger is pulling and dragging on the rear part of the trigger guard, ; it should also help reduce the sensed/felt pull.
Will post results later..thanks for tuning in .
Dan