Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Screwdrivers

Discussion in 'Blackpowder' started by MikeJackmin, Sep 18, 2006.

Thread Status:
Not open for further replies.
  1. MikeJackmin

    MikeJackmin Member

    Joined:
    Feb 24, 2005
    Messages:
    1,521
  2. sundance44s

    sundance44s Member

    Joined:
    Feb 6, 2006
    Messages:
    1,473
    Sundance44s

    My sugestion would be to buy a gunsmithing screwdriver that comes with the bit type ..so you can replace the bits when needed ..or add too the set .
    and not that expencive ..bought my set at wally world but have seen it many places like Cabelas or Sportsmanwarehouse and i bought extra bits at my local hardware stores . The right size bit for the job is important if you want to keep these guns looking their best .
     
  3. Smokin_Gun

    Smokin_Gun Member

    Joined:
    May 10, 2005
    Messages:
    1,632
    Location:
    Mojave Desert, California
    What Sundance said... I have had a Chapman Gun screw driver set for years...handle, ratchet, tips.
    But there is one particular size screwdriver that fits most everything on um. And a small one is also needed. Those Stanley sets(regular screw drivers) have both sizes in them. Either way not very expessive like Sundance said.
     
  4. 4v50 Gary

    4v50 Gary Moderator Staff Member

    Joined:
    Dec 19, 2002
    Messages:
    18,685
    You can always file a screwdriver to fit. I did that to make one of my Chapman bits fit the S&W revolver exactly.
     
  5. Tinker2

    Tinker2 Member

    Joined:
    Jun 10, 2005
    Messages:
    266
    Location:
    Dakota
Thread Status:
Not open for further replies.

Share This Page