SIG GRevolution question

[kestak]

Greetings,

I think my SIG 1911 Revolution has a little issue:

1 - Full cock, safety off, press the beaver tail safety, press the trigger: hammer goes down
2 - Full cock, safety on, press the beaver tail safety, press the trigger: hammer does not go down
3 - Half cock, safety off, press the beaver tail safety, press the trigger: hammer goes down!!!
4 - Half cock, safety on (in fact, it is half engaged), press the beaver tail safety, press the trigger: hammer does not go down
5-Half cock, safety off, -->does not press the beaver tail safety<--, press the trigger: hammer does not go down!!!!
6 - Sometimes, in case 4 or 5 the hammer does not go down.

"In the page 7 of the manual, they write: The safety intercept notch is a passive safety device that prevetns the hammer from falling if the primary sear notch dails....Using the safety intercept notch as a half cock position is a misuse of this feature and can result in untentiooanl discharge"

I just want to be sure, this is normal behaviour what I described in the 6 points. Right?

Thank you

 

[The Lone Haranguer]

That sounds normal to me.