Smith and Wesson 2206

Status
Not open for further replies.

Drakejake

Member
Joined
Dec 31, 2002
Messages
826
Location
Nashville, TN
I own two of these pistols. Each is stainless and has a six inch barrel. I shot both in the past few days. I shoot cheap value pack ammo from Wal-Mart. I have been shooting Federal hollow point from 550 round boxes. I am just a plinker so I am not picky about ammo if it works. The last two times I was shooting with a suppressor and had some jams. I don't know whether they were caused by the can or by my failure to clean the pistol. I think the 2206 with six inch barrel is a great value. I tried shooting them with an optical scope but this didn't work for me. I removed the scopes and shoot with the iron sights. These are accurate pistols with very good triggers.

I had an extra large padded gun case for the 2206. I added a strap and found that the case worked very well as a shoulder holster for the pistol with suppressor attached.

Drakejake
 

Attachments

  • IM002137.JPG
    IM002137.JPG
    362.5 KB · Views: 56
  • IM002138.JPG
    IM002138.JPG
    420.9 KB · Views: 15
  • IM002139.JPG
    IM002139.JPG
    468.2 KB · Views: 18
I've owned the 422 and 622. I always thought they were very reliable, accurate, and fun guns. Mine always would work with any brand of ammo I had on hand too.
 
This pistol works well with a suppressor. You can buy an adaptor on Gunbroker.com and use it to replace the barrel shroud. The suppressor screws right on, no barrel threading required. That is what I did.

Drakejake
 
Status
Not open for further replies.
Back
Top