Valkman
Member
A couple of weeks ago I asked my friend Teresa about trading for a flashlight she had and she turned around and just sent me 2 lights! Well, I had this CPMD2 Bird & Trout blank laying around and thought "Hmmm".
I had stag but it was too short for the handle - so I drilled hardened CPMD2 with a carbide end mill (only took me two!) and made a bolster and pinned it on. Then I put the stag on, and today ground it down and finished it.
I must've took 50 pics but none really show this knife as nice as it is!
Bird & Trout
1/8" CPMD2 - HT by Bos
416 SS bolster and pin
Stag handles - 1/8" mosaic pins
Hope you like it Sister T!
I had stag but it was too short for the handle - so I drilled hardened CPMD2 with a carbide end mill (only took me two!) and made a bolster and pinned it on. Then I put the stag on, and today ground it down and finished it.
I must've took 50 pics but none really show this knife as nice as it is!
Bird & Trout
1/8" CPMD2 - HT by Bos
416 SS bolster and pin
Stag handles - 1/8" mosaic pins
Hope you like it Sister T!