Now I need to get some stripper clips and see if it works
If it works, I'll duplicate it in steel. I'm not sure how much I can trust those little aluminum nubs, but cutting aluminum is so much less hassle for a prototype.
Thanks! I don't think it could be milled into the rear ring and still line up with the back edge of the magazine. I could move the magazine back a smidge, but I think it might start running into the rear action pillar.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.