Hey all. Trying to sell my girlfriend's Taurus 605. I went to clean it today, and discovered that the cylinder wouldn't stay closed. When the trigger is pulled, the hammer goes about 1/4 of the way back, and trigger travel stops at that point. Also, the cylinder release oddly enough stays forward, and if you pull it back, spring tension pushes it forward again. It's usually the opposite - it stays back unless pushed forward!
I know I could send it to Taurus, but if it's something simple (or something that's easy for my smith) I'd rather save the shipping. Any ideas? At this point I'd like to find the cheapest route to getting it right since it's headed for the classifieds.
Many thanks, all.
I know I could send it to Taurus, but if it's something simple (or something that's easy for my smith) I'd rather save the shipping. Any ideas? At this point I'd like to find the cheapest route to getting it right since it's headed for the classifieds.
Many thanks, all.