coldshot03/04
member
I have a used Taurus M44 44 mag revolver. I fired about 12 rds through it today and was planning to shoot some tommorrow. But Problem is, I was cleaning the revolver Cylinder holes, I ran about 3 tight fitting patches through the cylinder when all of a sudden the cylinder and yoke came off of the frame. I have never had this to happen to me with any other revolver that I have. I looked in the hole where the yoke goes and there was a cylinder stop plunger and spring. I fished it out and replaced it in the yoke and replaced the yoke and cylinder in the frame and tighened the screw on the side of the frame. Should I be concerned about the timing or anything? Everything looks to be working fine,but Im afraid to shoot it now. Please help.