Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

This really is addicting...

Discussion in 'Handloading and Reloading' started by allaroundhunter, Feb 4, 2013.

Thread Status:
Not open for further replies.
  1. allaroundhunter

    allaroundhunter Member

    Joined:
    Oct 5, 2011
    Messages:
    3,988
    Location:
    Southeast Texas
    Well, I haven't even started, I'm just about to get all of my supplies in (this weekend I should be loading! :D)... and I'm already looking for more...

    Now, I am hoping to get Varget or IMR 4064 to load for my .308, but I am now looking to start loading for my .243 as well.

    I have about 200 rounds of factory ammunition for deer and hogs, but I am thinking about making up a coyote load for it. I looked through Hodgdon's website and they have 65 gr V-Max loads that use these two powders (screaming around 3,700 fps), but I was wondering if these powders are less-than-ideal for this purpose?


    And no, I am not caring about keeping or selling the hides of the coyotes... I have a new vendetta against the critters after they killed my dog out of our backyard and I am just wanting to get rid of them. I figured an explosive V-Max would do the trick.
     
  2. Ky Larry

    Ky Larry Member

    Joined:
    May 22, 2003
    Messages:
    3,526
    Location:
    Ky
    Varget and IMR-4064 will work fine in .243 and .308. Also, IMR-3031 and Re-15 are excellent. I wish there was a shortcut to find what will work best in your rifles. The only load developement that works for me is to load lots of different loads and shoot 'em. Your rifle will tell you what it likes. Good luck with the 'yotes.
     
  3. James2

    James2 Member

    Joined:
    Nov 27, 2009
    Messages:
    878
    Location:
    Northern Utah
    Powders at that burn rate are fine for all the cartridges you mention. In today's market you may be fortunate to find what you want.

    I would suggest checking several loading manuals, or online loading data from the powder or bullet manufacturers and see what powders have been used with good results in those cartridges. Then go shopping and see what is available.

    You might also search the internet for powder burn rate charts, which give powders on a chart indexed from fastest to slowest. These are useful to pick a powder near the same burn rate as your first choice in case you can't find what you want.

    Click!
     
  4. James2

    James2 Member

    Joined:
    Nov 27, 2009
    Messages:
    878
    Location:
    Northern Utah
  5. allaroundhunter

    allaroundhunter Member

    Joined:
    Oct 5, 2011
    Messages:
    3,988
    Location:
    Southeast Texas
    Thanks for the info, Ky Larry!

    And James, that chart will be very helpful, thanks!
     
  6. mcdonl

    mcdonl Member

    Joined:
    Nov 24, 2008
    Messages:
    3,228
    Location:
    Southern Maine
    Also a needle and thread can solve many problems before putting them on the stretcher.

    I am going to try Barnes Varmint Grenades.
     
Thread Status:
Not open for further replies.

Share This Page