giggitygiggity
Member
- Joined
- Mar 18, 2009
- Messages
- 2,251
I have been using Titegroup for my .40SW and .45ACP loads. I fire the .40SW out of a Beretta 96 Brigadier and the .45ACP out of a Glock 30SF. I use 180gr .40SW bullets and 230gr .45ACP bullets. I have found these loads to be more accurate than factory ammo with recoil equivalent to factory ammo. Every single round has cycled flawlessly. I am loading just slightly less than maximum recommended loadinigs. The only negative thing I have to say about Titegroup is that it leaves burn marks on the brass.
Anyways, what does everyone else think of Titegroup? Are there any better powders. I went with Titegroup because it was the most cost-efficient powder. I am totally satisfied with the results and probably won't change anything regardless of posts. However, I just wanted to hear what other's impressions of Titegroup are. Thanks.
Anyways, what does everyone else think of Titegroup? Are there any better powders. I went with Titegroup because it was the most cost-efficient powder. I am totally satisfied with the results and probably won't change anything regardless of posts. However, I just wanted to hear what other's impressions of Titegroup are. Thanks.