Decided to install a Ghost Rocket 3.5 trigger in my Glock 21(non-ambi) today. Well to say the least it didn't go so well. The extended mag release and slide stop levers, as well as the aftermarket night sights were super easy to install so I figure I'd try my hand and putting in a new trigger connector. After grinding down the trigger control tab slightly I installed the connector and everything else back in. When I pulled the trigger to test things out the trigger "broke" like it should but felt real mushy. Second and subsequent trigger pulls failed to do anything, the trigger just pulls back with the resistance and springs back when released.
Here's where I am screwed. I can't get the slide off now. The trigger won't break, so I can't get the slide off when pulling down the slide lock levers. Is there another way to get the slide off the gun other than the obvious and normal procedure? Even if I have to break or damage something, Glock parts are pretty cheap and I will just chalk it up as a learning experience. Help a bonehead out please. :banghead:
Here's where I am screwed. I can't get the slide off now. The trigger won't break, so I can't get the slide off when pulling down the slide lock levers. Is there another way to get the slide off the gun other than the obvious and normal procedure? Even if I have to break or damage something, Glock parts are pretty cheap and I will just chalk it up as a learning experience. Help a bonehead out please. :banghead: