TStorm
Member
Does the small amount of walnut/corn cob media that gets into the flash hole during cleaning need to be cleared prior to reloading or will the depriming pin push this clear with the primer?
I'd estimate about 25% of the cases I've cleaned have a grain or two of media in the flash hole when they are done. I've tried to clear this with a 20ga (?) piece of copper wire, but this gets VERY tedious.
Still just prepping cases. LNL ordered and on backorder.
Thanks in advance!
I'd estimate about 25% of the cases I've cleaned have a grain or two of media in the flash hole when they are done. I've tried to clear this with a 20ga (?) piece of copper wire, but this gets VERY tedious.
Still just prepping cases. LNL ordered and on backorder.
Thanks in advance!