Lokichoki
Member
- Joined
- Nov 2, 2016
- Messages
- 297
my Taurus TX22 has been decently accurate, the rear sight has been maxed out in height and its shallow which obscures the sight picture but is serviceable. I recently was able to put a extremely lightweight suppressor on and the POI shifted significantly , it shot 3-1/2 feet low at 25ish yds! Happened with a different suppressor as well. I had already looked over how this design could be flawed, they made it easy to disassemble by doing away with a fixed barrel design by having the barrel slot into rails and lock in with the take down levers, being that the slide is aluminum they cant make use of it as another contact point the barrel floats through the slide (somewhat) . If the area where the barrel slides in is loose thats you consistent lockup is gone. With your suppressor adapter on make sure your weapon is clear and feel the play it has. My question is what would be the best way to remove the slop? Shim the barrel where it slides in? Have taurus send a barrel and hope it helps? Idk