I just acquired a Tyler T grip adaptor (my first) for my old S&W K frame round butt. It is a #3R , which the Tyler site says is for the aforementioned K frame round butt.
It is my impression that the upper , curved portion of the T Grip is supposed to fit slightly either side of the frame just behind the trigger guard. In my case the edges of the T Grip butt up against the outer edges of the frame , not allowing the casting to seat and conform to the revolver frame and grip. I hope this description makes sense.
Out of curiosity I tried the T Grip on an old J frame and it seemed to conform nicely. I did check that the casting is in fact marked 3R on the inside.
Please look at the images and let me know if my impression as to the proper fit is correct , and if the interface between the T Grip and my K Frame is normal. Just doesn't seem right ...
It is my impression that the upper , curved portion of the T Grip is supposed to fit slightly either side of the frame just behind the trigger guard. In my case the edges of the T Grip butt up against the outer edges of the frame , not allowing the casting to seat and conform to the revolver frame and grip. I hope this description makes sense.
Out of curiosity I tried the T Grip on an old J frame and it seemed to conform nicely. I did check that the casting is in fact marked 3R on the inside.
Please look at the images and let me know if my impression as to the proper fit is correct , and if the interface between the T Grip and my K Frame is normal. Just doesn't seem right ...