Wanting to get my Glock slide milled for an optic (where to go)

[horsemen61]

Hi everyone ok so I have a Glock 19 gen 3 and I am wanting to get the slide milled for an optic so here are my questions


1.) Where would you send it?

2.) what optic do you recommend?

 

[Shawn Dodson]

Jagerwerks.

 

[1KPerDay]

2) RMR type 2

 

[LeftyRed]

Jagerwerks

RMR Type 2, Holosun 507/407 if for EDC.
Swampfox if for range only.

JW has done three of my Glocks. Can’t ask for a better business to deal with.

I use RMRs for my EDC, non adjustable type. I trust the 407 as well. It’s solid and about half the price.

 

[needmorecowbell]

I decided to sell my Glock 19 and buy an already optic cut and upgraded Glock style Shadow Systems MR920. Both were used and only cost me $100 net. Cheaper than sending a slide out for milling. I love Armslist! Picked up the DR920 because liked so much. Have a Holosun 507c on both which I think is a great red dot. Having multiple reticle options is awesome

 

[sevt_chevelle]

Primary machine sells ready made glock slides cut for optics, the cost is like 250 bucks.

 

[LoonWulf]

@MachIVshooter was doing them for highroaders...... I think..... I remember that anyway.....

 

[MachIVshooter]

@MachIVshooter was doing them for highroaders...... I think..... I remember that anyway.....

I'm not anymore unless someone sends in 10+ at once. Doing one or two here and there is just too disruptive to my set up for suppressor work until I get a vertical machining center.

 

[LoonWulf]

I'm not anymore unless someone sends in 10+ at once. Doing one or two here and there is just too disruptive to my set up for suppressor work until I get a vertical machining center.

Understandable and good to know!