Hi guys, what size lathe and what spindle size and RPM are needed to be able to thread and chamber barrels?
I am guessing at least 1" and ideally 75rpm or less? How long distance between centres (as you don't need a lot of the barrel to thread and chamber)?
I only have a $1000 to spare right now, but looking through new lathes I figure this would be nearer to what is needed a 12" X 36"
http://www.machineryhouse.com.au/L183#
$3000
am I right? Could you do with a smaller one or would this a minimum?
I am guessing at least 1" and ideally 75rpm or less? How long distance between centres (as you don't need a lot of the barrel to thread and chamber)?
I only have a $1000 to spare right now, but looking through new lathes I figure this would be nearer to what is needed a 12" X 36"
http://www.machineryhouse.com.au/L183#
$3000
am I right? Could you do with a smaller one or would this a minimum?
Last edited: