What tumbler <$60?

Status
Not open for further replies.
Quoheleth, Your "green brass" error wasn't the vinegar/salt solution, as such, it is that you didn't flush/rinse it clean after the soaking and before it dried.
 
I have the Graf's one, and if I remember the warranty card correctly, it's also made by Berry's. It's rather noisy though, with it running I can't really have a conversation in the same room. Any suggestions?

Cameron
 
I have the Graf's one, and if I remember the warranty card correctly, it's also made by Berry's. It's rather noisy though, with it running I can't really have a conversation in the same room. Any suggestions?

Yep. Use my "Post-Ike Noise Comparison System."

Shut off all power in your house.
Crank up your 10hp generator and run it non-stop for 12 days.
Shut off the generator.
Turn on your tumbler.
It will seem like a mouse's whisper. :p

Seriously...put it on a piece of rubber matting, like OSHA recommends for standing on at work. If that doesn't help, take the conversation elsewhere. :eek:

Q
 
Frankford was not good for me. Lower motor bearing failed almost immediately. I replaced the bearing, then the one of the wires worked its way out of the connector crimp.
I also have an old Lyman, and although I liked the clear lid on the Frankford, the Lyman is much quieter as compared to the Frankford with good bearings.
 
i just picked up a vibrator tumbler at harbor freight on sale for $40, plus a 25# bag of walnut shells for $10...tumbled about 400 9mm cases for less than an hour and they were clean and shiny!!! just added a dryer sheet to the dry media to attract dust. couldn't be happier!!!
 
Status
Not open for further replies.
Back
Top