Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Who Does Action Jobs on GP-100s?

Discussion in 'Handguns: Revolvers' started by Kestrel, Jan 11, 2003.

Thread Status:
Not open for further replies.
  1. Kestrel

    Kestrel Member

    Joined:
    Dec 26, 2002
    Messages:
    2,168
    Does anyone know of a good gunsmith that does action jobs on Ruger GP-100s? I have one that must have a 20 lb. DA trigger pull. Amazing. Single action feels like it's almost 10 lbs.

    Thanks for any help,
    Steve
     
    Last edited: Jan 11, 2003
  2. GrandmasterB

    GrandmasterB Member

    Joined:
    Dec 31, 2002
    Messages:
    732
    Location:
    Fort Worth, TX
    Teddy Jacobson can work wonders with your GP-100. www.actionsbyt.com

    I have two guns done by him, a Beretta 92FS and a S&W 625. Both triggers are completely smooth and MUCH lighter than factory. You WILL be pleased.
     
  3. WESHOOT2

    WESHOOT2 Member

    Joined:
    Dec 29, 2002
    Messages:
    854
    Location:
    Vermont
  4. Rob96

    Rob96 Member

    Joined:
    Dec 28, 2002
    Messages:
    1,504
    Location:
    Allentown, PA
    Check the revolver section over at www.rugerforum.com, I believe Tom Novak, aka HANDGUNNER, does this work.
     
  5. HSMITH

    HSMITH Member

    Joined:
    Dec 26, 2002
    Messages:
    4,933
    Check the revolver section over at www.rugerforum.com , I believe Tom Novak, aka HANDGUNNER, does this work.


    Fixed the link ^^^^^^ is all.
     
  6. MR.G

    MR.G Member

    Joined:
    Dec 26, 2002
    Messages:
    609
    I installed a Wolf reduced tension spring kit in mine. Made a big difference in the double and single action trigger pull. Innexpensive, and you can do it yourself. You might want to try it. If you were close by I would give you a set to try and see how they work in your gun.
     
Thread Status:
Not open for further replies.

Share This Page