I was going through some brass that I shot - and one of the rounds was 30-30 factory loads that I shot a year or so ago in a Winchester 94. I noticed several of the case mouths have sort of a bent over flat spot, and most of them appear to have some sort of bend to the case mouth.
I sort of stared at it for a while. Not sure if that is from extraction, or possibly spinning and hitting the concrete floor at the range just right. Or if that is cause by some other problem?
I did some searching/reading and it appears a fairly common problem with auto-loaders, but I didn't find so much on lever guns.
I sort of stared at it for a while. Not sure if that is from extraction, or possibly spinning and hitting the concrete floor at the range just right. Or if that is cause by some other problem?
I did some searching/reading and it appears a fairly common problem with auto-loaders, but I didn't find so much on lever guns.