Winchester 94 top eject parts

[Onael]

Hello. Can anyone point me to a source that sells the screws to fill the two little holes on the left side of the receiver where the scope its supposed to be mounted? I've looked and the only thing I can find are the screws for the AE models. If anyone here has any would you be willing to sell?
Thank you

 

[rcmodel]

They are called plug screws.

Any gunsmith, or Brownell's or Midway sell them.

I don't recall what size they are right off hand, but most likely 6x48 if they are factory receiver sight holes.
If they are truly scope mount holes?
Somebody drilled & tapped the receiver, as 94's were not drilled for scope side-mounts from the factory.
In that case, they could be anything?

http://www.brownells.com/.aspx/pid=792/Product/PLUG-SCREW-KIT

rc

 

[Onael]

Thank you for that link. Didn't even know Brownells had a miscellaneous parts section.

 

[airedaleman]

By the way, those two little holes are for a receiver sight, not a scope mount.

 

[rcmodel]

I thought I said that in post #2?

rc

 

[DPris]

Say it again, you were too quiet.
Denis

 

[airedaleman]

RC, you surely did... ancient eyes lead to poor reading habits...

 

[CraigC]

The two little holes are for a receiver sight, not a scope mount.

Far as I know, they are 6-48. Don't try to find them at the local hardware store, they'll have to come from a gunsmithing supply house like Brownells or your local gunshop may have a few. Just a standard plug screw. Doesn't hurt to have a bag of them on hand, just in case.