New Remington 700 milspec buildup

I got the itch for rifle a while back and so when the remington 700 milspec came into my local gunshop on a transfer I could finally put my hands on it, I then had the shop order me one just like it(700 milspec 5R in .308). It arrives today so pictures will be up soon.

For scope mount I chose a Leopold picatinny(sp) one piece and leopold 30mm rings

I will be lapping these in to insure the leopold mark 4 4.5-14x50 long range mil-dot scope fit is perfection

Out front will be a harris 6-9" ultralite iPod

Eventually it will get a magazine setup.

Any suggestions or knowlege on this will be much appreciated

do you think with the EGW i will need lows or mediums on the seekins rings?

ill send the leopoulds back

We'll I got the scope in 40mm instead of 50mm due to a $300 difference

I meant to take pictures of it and its wicked muzzle flash but will do it thursday

The irony is that I have only been able to shoot 20 yards. I did a 20 round break in and now ready to do some more research and go long range with it.

Your right the only thing I plan to change is the dinky recoil pad, for now.

I plan to use factory match ammo till I put many more rounds down the barrel and then get my reloading stuff together.

Not that a surprise but it put 15 of 20 in same hole with 2 shooters with little rifle experience. We pulled a couple but that was us.

I currently shoot 300 rnds a week so reloading is in my near future for sure

Now I need to study up on distance shooting