I have used both RCBS and LEE. I have found that lee dies are a little smoother inside than RCBS. I have gotten cases stuck in the RCBS die, never LEE. no I did not change lube or amount of lube. as far as lube goes, I use hornady unique. lasts a long time and it is GOOD.
you may want to put a little crimp on you cases after loading this will ensure you have the pressure needed to cycle some autoloaders. it will also ensure you bullet/case is still in line with one another .
any one got any tips or tricks for the combo santa gave to me the year. i have set it up and calibrated it and started to dump powder. any hints, tricks, or stay away froms, you can send my way
I have the SPS varmint and it came with the 1:12 twist. I have loaded 150s and 168s in it and they did not do to good. the only good load with 150s was with norma powder and that is very hard to find around my parts. about 3 inch was the best with 168s. I finally stuck with 130 grn barnes w/46...
i have the model you speak of in 338 ultra mag. it is a BDL. nothing more just BDL I have three 700s the ADL,BDL and SPS. Ditch is correct in his post.
new guy
sorry it took so long to post here. just looked at this thread.
well here goes. I am 18 + years navy chief. I am originally from oakman alabama, a small town near birmingham. Been reloading for 17 years and hunting all but 5 years of my life. I have aquired several long guns over...
are you gonna eat em. if not then anything from 17 to 50 cal will do just fine. these little suckers around here need killin bad. if I could i would set up land mines. they are destroying neighbors homes by diggin through the roofs and outside walls. when ever I can I kill em. so no 17 is not...
to bed a synthetic stock it has been my practice to use a flame tourch to NOT melt but heat up the stock where you want your appoxy to stick. remember do not melt but just heat it up. you will be able to see the poors open up in the stock.
remington 700 BDL/338 remington ultra mag. scope leupold. according to the ballistics tables and my scope. I cannot get enough elevation out of my scope to get me to 1000 yds. I have a two piece base. but with the advise you guys have given looks like I will be buying a one piece.
I reload because it cheaper than factory. but if I went to the range as often as I wanted then price difference would be taking the other route. I like to develope loads for multipurpose shooting. I just can't leave well enough alone. I like to see the result of hard work (hard work LOL).
http://www.midwayusa.com/viewproduct/?productnumber=758495&utm_source=froogle&utm_medium=free&utm_campaign=9315
thry the link above. I have been using this type of case lube for years. when I first purchaced it I bought several tubs. I am still working on my first tub. have loaded several...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.