Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

.250 Savage Brass needed

Discussion in 'Handloading and Reloading' started by testar77, Jan 22, 2010.

Thread Status:
Not open for further replies.
  1. testar77

    testar77 Member

    Joined:
    Feb 10, 2005
    Messages:
    328
    Location:
    Kennewick, Wa.
    not sure if I should post this in here but I wanted to target the right crowd ;) lookin to swap some brass, I need some .250 Savage Brass and would be willing to swap for some. I have all kinds of different brass. So if you have any let me know what you need and I will take a look.


    Thanks, Toby
     
  2. the_right_reverend

    the_right_reverend Member

    Joined:
    Mar 14, 2008
    Messages:
    154
    Location:
    Sneads Ferry, Nc
  3. Jefferson Herb

    Jefferson Herb Member

    Joined:
    Nov 15, 2008
    Messages:
    391
    Location:
    south west state of Jefferson
    250 savage

    If You can't find anything else 22-250 brass would work.The necks might be thin,if careful should'nt split.It's easier to go down than up,but iform 7mm tcu from .223 and do it in one pass. I use imperial sizing wax.
     
  4. Zeke/PA

    Zeke/PA Member

    Joined:
    Feb 24, 2005
    Messages:
    2,299
    Location:
    Southeastern Pa.
    How much do you need?
    Graf has it for $ 28.00/50
     
    Last edited: Jan 24, 2010
  5. testar77

    testar77 Member

    Joined:
    Feb 10, 2005
    Messages:
    328
    Location:
    Kennewick, Wa.
    well I was hoping to try and find someone to swap with so I didn't have to buy any, as things are tight these days :eek:
     
  6. Zeke/PA

    Zeke/PA Member

    Joined:
    Feb 24, 2005
    Messages:
    2,299
    Location:
    Southeastern Pa.
    testar,
    How much do you need?
     
  7. testar77

    testar77 Member

    Joined:
    Feb 10, 2005
    Messages:
    328
    Location:
    Kennewick, Wa.
    Ultimately would like to have 100+ on hand, but will take whatever I can get right now. If you have some to get rid of, let me know what calibers you load for and I will see what brass I have to trade.
     
Thread Status:
Not open for further replies.

Share This Page