Flash Gordon
Member
I have found that my .45 Auto case lengths vary from the maximum of .898 to as short as .882. Most are between .888 and .892. How important is it to trim these cases to make them all the same length? I used to think that it didn't matter because I could get the COAL to be the same for all of them anyway, but now I think I was wrong.
I don't relish trimming cases, but maybe I should. Any comments would be appreciated. Is the difference between
.888 and .892 enough to worry about? Should I trim them so they are all exactly the same? Thanks.
I don't relish trimming cases, but maybe I should. Any comments would be appreciated. Is the difference between
.888 and .892 enough to worry about? Should I trim them so they are all exactly the same? Thanks.