ASM walker U.S.M.R

[NickAlbion]

Any one have the diameter for Uberti walker barrel line up pins?

 

[99whip]

I do not, you could make some from a nail though.

 

[4v50 Gary]

Pardon my ignorance, but what is a barrel line up pin?

 

[Berkley]

 

[Acera]

I do not, you could make some from a nail though.

I would suspect that the steel in a drill bit would be better suited for that job. Probably easier to find the correct size also.


.

 

[LonesomePigeon]

I don't know but VTI Gunparts sells them.

 

[45 Dragoon]

Actually, they're just for locating so a softer nail would be better than drill stock. If you ever needed to replace one, it's much easier to drill out soft steel. They need to be "fitted" anyway.

Mike

 

[whughett]

AS it happens the one to the photos right is a finish nail. Just find one that's a tight fit, tap it in and cut to length. This ones been there a couple of years and many takedowns. It's an 1860 however.

 

[NickAlbion]

tks everyone for your responses and ideas. I did find the pins available at taylors firearms. turns out uberti pins and ASM are the same size.

 

[LonesomePigeon]

"turns out uberti pins and ASM are the same size."
That's good to know. Glad you got it sorted.

 

[4v50 Gary]

Thanks Berkley.