capreppy
Member
From my other thread regarding lowering my ES on loaded rounds, I am going to neck turn my brass. I will also do some of the other steps, but this is where I am seeking advice.
I will be ordering the 21st Century Neck Turning Lathe. It is a little expensive, but the ease of setup and consistency have me leaning that route.
What is the best method for determining what to neck turn down to? Is there a suggested minimum?
The brass that I will be neck turning:
223 Rem - Winchester headstamp (avg of 0.0095 thickness)
6.5 Creedmoor - Hornady headstamp (avg of 0.0115)
300 Win Mag - FC headstamp (TBD)
I will be ordering the 21st Century Neck Turning Lathe. It is a little expensive, but the ease of setup and consistency have me leaning that route.
What is the best method for determining what to neck turn down to? Is there a suggested minimum?
The brass that I will be neck turning:
223 Rem - Winchester headstamp (avg of 0.0095 thickness)
6.5 Creedmoor - Hornady headstamp (avg of 0.0115)
300 Win Mag - FC headstamp (TBD)