Fat_46
Member
I've got a Blackhawk in 357 I rescued (from its appearance when I found it at a garage sale it was obviously someone's truck gun, probably kept in a toolbox). The issue I'm running into is the hammer doesn't push the cylinder latch down. If i open the gate, the latch goes down just fine, and if I rotate the cylinder so the latch isn't in a cylinder slot it cocks fine.
Any ideas? While not terribly difficult, my comfort level disassembling it that far is a bit shaky.
Thanks!
Any ideas? While not terribly difficult, my comfort level disassembling it that far is a bit shaky.
Thanks!